Ferrous Crete is a leading manufacturer of Polymer modified adhesives in India. The company is primarily located in Faridabad, Haryana.


Ferro – 201 stone sealer is a high strength sealer for porous building materials, natural stones, bricks, pavers, marbles, sand stones, granites, porous tiles and grouts, Our sealer penetrate much deeper and bonds superior inside the pores of the treated material and creating invisible oil and water repellent barrier. Ferro- 201 stone sealer not only reduces the stains, but also able to protect from serious common structural damage liquids, salt attack, efflorescence and inhabits the growth of mosses and moulds in the porous of the treated material. It different from conventional (mono functional) water repellents. The pores of the substrate remain open. The water vapor diffusion is hardly affected if at all oil, grease, paint etc. are easier to remove from surface that have been treated with Ferro – 201 sealer. It is for use in green building.


  • Description


    Treatment of floors of natural or synthetic stones, ceramic tiles, fibrous cement, facades natural and synthetic stone, marble and granite.

    • Designed for indoor or outdoor use
    • Water and oil resistant
    • Protects the interior and exterior use
    • Easy to use
    • Ideal for use in green building
    • Water, oil and dirt repellent treatment of low porosity natural stone e.g marble, travertine
  • Technical Data

    Test Unit Approx.Result
    Colour Milky White
    Non Volatile Content Approx % 5
    PH Approx. % 6 to 7
    Flash Point Approx. 0ºC >100
    Density Approx. g/cm3 0.98
    VOC Content Approx. g / L <300
    Specific Gravity at 25ºC Approx. 0.985
    Solvent Water
  • Additional Information

    • Pack Size : 5 ltr.

    • Test a small unobtrusive area before coating entire surface
    • Stir well before use
    • Apply to penetrate 20 to 30 minutes
    • Mostly one coat is sufficient
    • More porus surface should have two applications
    • Apply second coat absorbent surface 30 to 40 minutes after first coat
    • Remove excess sealers from surface
    • Allow sealer to cure for 48 hours